Whirlpool GARAGE REFRIGERATOR Lower Front Corner, Lower Rear Corner, Complete the Installation

7.Remove the casters and fasteners from the box.

8.Locate and remove the caster brackets from the FeaturePak.

9.Using ⁵⁄₁₆–18 x ⁷⁄₈” hex-head bolts, attach one rigid caster and one swivel caster to each caster bracket. The rigid caster fits the front of the bracket and the swivel caster fits on the rear.

10.Insert the hex-head bolts from the bottom and start the self- locking nuts for each caster.

A

B

	C
	D
A. Self-locking nut	C. ⁵⁄₁₆–18 x ⁷⁄₈" Hex-head bolt
B. Caster bracket	D. Caster

11.Hold the head of the hex-head bolts with a wrench while tightening the self-locking nuts with a socket wrench.

12.Using a ¹⁄₂" socket wrench, remove the four unit bolts (two on each side) from the lower front and rear of the refrigerator.

NOTE: Do not remove leveling bolt.

Lower Front Corner

A

B

A. Leveling bolt (do not remove)

B. Refrigerator/freezer unit bolt

13.Place the slot in the rear of the caster bracket over the unit hole in the rear of the refrigerator. Align the hole in the front of the caster bracket with the unit hole in the front of the refrigerator.

Lower Rear Corner

A

B

A. Refrigerator/freezer rear unit hole

B. Caster bracket

14.Hold the bracket in place and insert the unit bolts into the front and rear unit holes and tighten.

NOTE: Do not overtighten the bolts.

15.Insert two of the ¹⁄₄–20 x 1¹⁄₄" self-tapping hex-head bolts and lock washers into the two holes in the side of the caster bracket. Push the caster bracket against the bottom of the refrigerator and tighten the bolts using a ³⁄₈" socket wrench.

A

A. Caster bracket holes

16.Repeat steps 12 to 15 for the other caster bracket.

Complete the Installation

1.Lock the front casters.

NOTE: Locking the casters will help prevent the refrigerator from moving while it is being lifted.

2.Insert a small piece of cardboard between the caster brake and the floor. This will help prevent the brake from rubbing on the floor.

8