Whirlpool GDP6881XL manual POWER CLEAN”’ Washing System, Step-savingpreparation for washing

POWER CLEAN”’ Washing System

Your dishwasher cleans by spraying a mixture of hot, clean water and detergent against soiled surfaces of dishes. When a cycle is started, the dishwasher fills with water to about the level of the heating element. This water is pumped through the rotating

spray arms, through the POWER CLEAN Module which removes food particle&and back through the rotating spray arms. Soiled water is pumped out and replaced with clean water during a cycle - the number of times depends on the cycle being used.

The POWER CLEAN* Module removes food

particles from the water, stores them, then washes them down the drain.

Load dishes so soiled surfaces face pow- erful spray from rotating arms.

Step-saving preparation for washing

It is	not	necessary
to rinse	dishes		before
putting	them		into	the
dishwasher.			Just	re-
move	large		pieces,
bones,	and	other hard
items.	The		POWER
CLEAN	Module			will
remove	food		parti-

Hot water is a must

/	Hot	water	dissolves
	and	activates		the
	dishwashing		deter-
	gent. Hot water dis-
	solves	grease		on
	dishes	and helps		dry
	glasses	spot-free.
	Make	certain	loads
	are washed		in	hot
	water	fat leastl40”F		-
Check Water	6O’C):	Two	ways	to
	have	a reliable		hot
Temperature	water	supply...

1.Maintain 140°F water supply at central water heater. To check water temperature,

cles from the water. It contains a chopping de- vice which will reduce the size of food items.

If hard items such as fruit seeds, nuts and egg shells enter the POWER CLEAN Module,

You might hear chopping, grinding, crunch- ing or buzzing sounds. Those sounds are nor- mal when hard items enter the module. DO NOT LET METALLIC ITEMS GET INTO THE POWER CLEAN MODULE.

turn on hot water faucet nearest the dish- washer. Let water run until it is as hot as pos- sible, then check with a candy or meat

thermometer. If the temperature is too low,

have a qualified person raise the water heater thermostat setting.

2.Use HI-TEMP WASHING Option. If water heat- ing is needed, a thermostat will delay the

cycle until temperature reaches 145 F (63:‘C). If water is hot enough, the cycle will

proceed with no delay. This lets You turn down Your water heater, if You choose, without cutting back on hot water needed for good dishwashing.

Tmk.

4