Whirlpool GSC278 YGSC278 manual Troubleshooting, Oven Lights, Oven Door, To Replace, To Remove

Oven Lights

The oven lights are standard 40-watt appliance bulbs. They will come on when the oven door is opened. They will not work during the Self-Cleaning cycle. When the oven door is closed, press OVEN LIGHT to turn them on or off.

To Replace:

Before replacing, make sure the oven is off and cool.

1.Disconnect power.

2.Turn the glass bulb cover in the back of the oven counterclockwise to remove.

3.Turn bulb counterclockwise to remove from socket.

4.Replace bulb and bulb cover by turning clockwise.

5.Reconnect power.

Oven Door

For normal range use, it is not suggested to remove the oven door. However, if necessary, follow these instructions. The oven door is heavy.

To Remove:

1.Open oven door all the way.

2.Flip up the hinge latch on each side.

3.Close the oven door as far as it will shut.

4.While holding the oven door on each side with both hands, lift the oven door up.

Continue to push the oven door closed and pull it away from the oven door frame.

To Replace:

1.Insert both hanger arms into the door.

2.Open the oven door.

You should hear a “click” as the door is set into place.

3.Move the hinge levers back to the locked position. Ensure that the door is free to open and close. If not, repeat the removal and installation procedures.

TROUBLESHOOTING

Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.

Nothing will operate

■Has a household fuse been blown or has the circuit breaker been tripped?

Replace the fuse or reset the circuit.

■Is the appliance wired properly? See Installation Instructions.

Oven will not operate

■Is the electronic oven control set correctly? See “Electronic Oven Control” section.

■Has a delay start been set? See “Timed Cooking” section.

■On some models, is the Control Lock set? See “Control Lock” section.

■On some models, is the Sabbath Mode set? See “Sabbath Mode” section.

■On double oven models, is one oven self-cleaning? When one oven is self-cleaning the other oven cannot be set or turned on.

■On double oven models, has the correct oven been selected?

Choose UPPER OVEN or LOWER OVEN first.

Oven temperature too high or too low

■Does the oven temperature calibration need adjustment? See “Oven Temperature Control” section.

Display shows messages

■Is the display showing “PF”, “PF id=27” or “PF id=30”? There has been a power failure. Clear the display. See “Display(s)” section. On some models, reset the clock, if needed. See “Clock” section.

14