Whirlpool JMC2130 Electrical Requirements, Minimum Installation Clearances, Electrical Connection

Models: JMC2127 JMC2130

1 16
Download 16 pages 31.19 Kb
Page 4
Image 4

NOTE:

A microwave oven spacer kit is available from your dealer that will allow the microwave oven to be installed in an 18¼" (46.4 cm) to 19⁷⁄₁₆" (49.4 cm) maximum cutout height. Match the color and size to the following kits:

Microwave Oven Spacer Kit

27" (68.6 cm) Black - Model JMCSK27WB

27" (68.6 cm) Stainless Steel - Model JMCSK27WS

30" (76.2 cm) Black - Model JMCSK30WB

30" (76.2 cm) Stainless Steel - Model JMCSK30WS

To order, see the “Assistance or Service” section of the Use and Care Guide.

Minimum Installation Clearances

For proper installation the following minimum clearances must exist above and below the cabinet opening.

Installation Above Single Built-In Oven

A

1"

(2.5 cm)

1"

(2.5 cm)

B

A. Upper cabinet

B. Lower single oven*

*Approved models: JJW3430, JJW2430, JJW2427, JJW2330, JJW2327

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

GROUNDING INSTRUCTIONS

For all cord connected appliances:

The microwave oven must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. The microwave oven is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.

WARNING: Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt exists as to whether the microwave oven is properly grounded.

Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the microwave oven.

SAVETHESE INSTRUCTIONS

Electrical Connection

Microwave oven must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate. The model/serial number rating plate is located on the left-hand side trim.

A

A. Model/serial number plate

Observe all governing codes and ordinances.

Required:

A 120 Volt, 60 Hz, AC only, 15- or 20-amp electrical supply with a fuse or circuit breaker.

Recommended:

A time-delay fuse or time-delay circuit breaker.

A separate circuit serving only this microwave oven.

4

Page 4
Image 4
Whirlpool JMC2130 Electrical Requirements, Minimum Installation Clearances, Installation Above Single Built-In Oven