Whirlpool JQ 276 manual SET Clock, Weight Sensor, Weight Sensing Calibration

SET CLOCK

WHEN THE APPLIANCE IS FIRST PLUGGED IN or after a power failure, the

product will enter clock setting. If the clock is not set, the display will remain “:“ instead of the clock.

NOTE: YOU CAN PRESS&HOLD FOR A FEW SECONDS THE STOP BUTTON in

standby mode to access the clock setting mode.

qTURN THE ADJUSTABLE KNOB to set the hours.

wPRESS KNOB BUTTON. (The two right-hand digits (minutes) flicker).

eTURN THE ADJUSTABLE KNOB to set the minutes.

rPRESS THE KNOB BUTTON AGAIN.

THE CLOCK IS SET and in operation.

IF STOP is pressed in clock setting mode, the clock will be disabled the display shows “:“.

NOTE: KEEP THE DOOR OPEN WHILE SETTING THE CLOCK. This gives you 10

minutes to complete the setting of the Clock. Otherwise, each step must be accomplished within 60 seconds.

WEIGHT SENSOR

THIS MICROWAVE OVEN USES THE WEIGHT SENSOR TECHNOLOGY for some 6th sense functions (Defrost, Crisp

and Steam); when you select one of these 6thSense functions, you just need to select type of food you want to process and press start: the microwave automatically detects the weight of food and set the cooking time accordingly.

DURING THE SENSING PHASE weight icon blinks and progress bar shows the weight calculation process (see sample below, from 6th Defrost function).

WEIGHT SENSING CALIBRATION

Weight sensor technology requires a Calibration process before first use. Suggest user to make the calibration once a year.

THE CALIBRATION PROCESS MUST BE DONE with only the Turn Table glass in the cavity.

PRESS AND HOLD for few seconds the Stop TurnTable button.

THE CALIBRATION PROCESS starts and the display shows:

--weight icon blinking

--calibration progress bar

WHEN THE CALIBRATION PROCESS is finished, the Microwave returns to stand by mode.

10 GB