® 30" Freestanding and Slide-In Dual Fuel Range
PRODUCT MODEL NUMBERS
KDRS807S KDSS907S
KDRS807X KDSS907X
GAS SUPPLY REQUIREMENTS
PRODUCT DIMENSIONS
Freestanding Range |
Provide a gas supply line of ³⁄₄" (1.9 cm) rigid pipe to the range location. A smaller size pipe on longer runs may result in insufficient gas supply.
152.4 cm) long, ¹⁄₂" (1.3 cm) or ³⁄₄" (1.9 cm) I.D., |
flexible metal appliance connector may be used for |
connecting range to the gas supply line. A ¹⁄₂" |
(1.3 cm) male pipe thread is needed for connection |
to the female pipe threads of the inlet to the |
appliance pressure regulator. The supply line must |
be equipped with a manual shutoff valve. This valve |
30"
(76.2 cm)
5³⁄₄"
(14.6 cm)
36" (91.4 cm) cooktop trim height with leveling legs screwed all the way in*
41³⁄₄"
(106 cm) overall height with leveling legs screwed all the way in*
30⁹⁄₁₆"
(77.6 cm)
23" (58.4 cm)
countertop
notch to rear of countertop
35⁵⁄₈" (90.5 cm) height to underside of cooktop edge with leveling legs screwed all
the way in*
Model/serial number plate (located on the
should be located in the same room but external to |
the range. It should be in a location that allows ease |
of opening and closing. |
ELECTRICAL REQUIREMENTS
27¼" (69.2 cm) max. from handle to
standoff at back of range**
Model/serial number |
|
plate (located on the | 27¼" (69.2 cm) max. |
(27¹¹⁄₁₆" [70.3 cm] | |
oven door trim) | on model KDSS907XSP) |
| from handle to standoff |
| at back of range** |
30"
(76.2 cm)
When a
†®TEFLON is a registered trademark of E.I. Du Pont Nemours and Company.
*Range can be raised approximately | *Range can be raised approximately |
1" (2.5 cm) by adjusting the leveling legs. | 1" (2.5 cm) by adjusting the leveling legs. |
**When installed in a 24" (61 cm) base cabinet | **When installed in a 24" (61.0 cm) base cabinet |
with 25" (63.5 cm) countertop; front of oven | with 25" (63.5 cm) countertop; front of oven |
door protrudes 1" (2.5 cm) beyond 24" | door protrudes 1³⁄₄" (4.4 cm) (2³⁄₁₆" [5.5 cm] on |
(61 cm) base cabinet. | models KDRS807XSP and KDSS907XSP) |
| beyond 24" (61.0 cm) base cabinet. |
SLIDE-IN COUNTERTOP PREPARATION
30"
(76.2 cm)
³⁄₈"
(1.0 cm)
30¾"
(78.1 cm)
The cooktop sides of the
If you have a square finish (flat) countertop and the opening width is 30" (76.2 cm), no countertop preparation is required.
Formed
Tile countertops may need trim cut back ³⁄₈" (1.0 cm) from each front corner and/or rounded edge flattened.
If countertop opening width is greater than
30" (76.2 cm), adjust the ³⁄₈" (1.0 cm) dimension.
Countertop must be level. Place level on countertop, first side to side; then front to back. If countertop is not level, range will not be level. Range must be level for satisfactory baking conditions.
INSTALLATION CLEARANCES
| Freestanding Ranges |
|
|
|
|
| ||
| 13" (33 cm) upper | For minimum |
|
| 13" (33 cm) max. | For minimum | ||
| clearance to top |
|
| clearance to top | ||||
| cabinet depth | of the cooktop, |
|
| upper cabinet depth | of the cooktop, | ||
| 30" (76.2 cm) min. |
| see NOTE. |
|
| 30" (76.2 cm) min. |
| see NOTE. |
|
|
|
|
|
|
| ||
| opening width |
|
|
|
| opening width |
|
|
18" (45.7 cm) |
|
|
| 18" (45.7 cm) |
|
| 22¹⁵⁄₁₆" (58.3 cm) | |
|
|
|
| ³⁄₄" (1.9 cm) | opening depth | |||
upper cabinet | 30" (76.2 cm) |
|
| upper cabinet |
|
|
| |
to countertop | min. opening |
|
| to countertop |
| radius both corners |
| |
| width |
|
|
|
| 30" (76.2 cm) |
| |
|
|
|
|
|
| min. opening |
| |
|
|
|
|
|
| width |
| |
|
| This shaded area | Cabinet door |
|
|
| This shaded area | Cabinet door |
|
| 5" (12.7 cm) min. |
| 6" | recommended | or hinge | ||
| 8" | recommended | or hinge |
| ||||
5" (12.7 cm) min. | clearance from |
| (15.2 cm) | for installation | should not | |||
(20.3 cm) | for installation | should not |
| |||||
clearance from | extend into | both sides of the |
|
| of outlet or | extend into | ||
both sides of the |
| of outlet or | range to the side |
| 6" | junction box. | the cutout. | |
8" | junction box. | the cutout. |
|
| ||||
range to the side |
|
| wall or other | (15.2 cm) |
|
| ||
wall or other | (20.3 cm) |
|
| combustible |
| 7" (17.8 cm) |
|
|
combustible | 7" (17.8 cm) | 4¹⁄₂" |
| material. |
| 4¹⁄₂" |
| |
material. |
|
|
|
| (11.4 cm) |
| ||
|
| (11.4 cm) |
| This shaded area |
|
|
|
|
This shaded area |
|
|
|
|
|
|
| |
|
|
| recommended for |
|
| Available |
| |
recommended for |
|
|
| installation of |
| 1¹⁄₂" |
| |
installation of | 1¹⁄₂" | Available |
| rigid gas pipe. |
| (3.8 cm) | area for |
|
rigid gas pipe. | (3.8 cm) | area for |
|
|
|
| gas and |
|
|
| 4¹⁄₂" |
| electric |
| |||
|
| gas and |
|
|
| |||
4¹⁄₂" |
| electric |
| (11.4 cm) | installation. |
| ||
(11.4 cm) | installation. |
|
|
|
|
|
| |
NOTE: 24" (61 cm) minimum when bottom of wood or metal cabinet is covered by not less than ¹⁄₄"
(0.64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an uncovered wood or metal cabinet.
If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface.
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation | Ref. W10246120C |
Instructions packed with product. Specifications subject to change without notice. | 1/28/11 |
