Other operating instructions For a rinse and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent [Extra de-
tergent can require an extra rinse )
l
Push Control Knob In
l
Turn clockwise to any
l
on the dial
See above drawing.
l
Pull Control Knob out
l
The washer will fill to selected level
with cold water, agitate 2 minutes,
drain and spin
For a soak
For best results, use warm water
for soaking stained laundry Hot
water can set stalns.
r
For a drain and spin
Your washer can be set to drain
and spin out water
l
Push Control knob in
l
Turn clockwise to the bar just before
OFF In any cycle. See above
drawing.
l
Pull Control Knob out.
l
The washer will drain and spin.
l
Use recommended amount of
detergent or pre-soak product.
l
Push Control Knob in.
l
Turn clockwise to point at a number
in the SOAK Cycle!..use the 12-
minute mark for a pre-wash.
l
Pull Control Knob out to start washer.
l
When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
information on page 7 of your
“Laundry Guide!’
l
Set the washer and start the next
selected wash cycle.
‘To start soak with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.
Cleaning the lint filter
Water runs through the lint filter
whenever the washer agitates.
Check it often to make sure it’s clean
and is filtering at its best.
To remove it for cleaning, press the
release and pull straight out. Instruc-
tions for cleaning are printed on the
bottom of the filter.
10