INSTALLATION REQUIREMENTS
ToolsandParts
Tools Needed
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
RemoveCardboardTemplate
The cardboard piece from the top of the microwave oven packaging is perforated. The piece inside the perforation is for use as a rear wall template.
1. Cut along the perforation to separate the template from the |
rest of the cardboard packaging. |
■Measuring tape
■Pencil
■Masking tape or thumbtacks
■Scissors
■No. 2 Phillips screwdriver
■No. 3 Phillips screwdriver for
■Electric drill
■3/16" (5 mm), 3/8" (10 mm) drill bits
■3/4" (19 mm) hole saw
■Stud finder
■7/16" socket wrench
(or box wrench) for 1/4" x 2" lag screws
■1½" (3.8 cm) diam. hole drill bit for wood or metal cabinet
■Keyhole saw
■Caulking gun and weatherproof caulking compound
■Duct tape
2. Set the cardboard template to the side and refer to it during |
the “Mark Rear Wall” part of installation. |
LocationRequirements
Check the opening where the microwave oven will be installed. The location must provide:
■ Minimum installation dimensions. See “Installation |
Dimensions” illustration. |
■ Minimum one 2" x 4" (50.8 x 101.6 mm) wood wall stud and |
minimum 3/8" (10 mm) thickness drywall or plaster/lath within |
cabinet opening. |
■ Support for weight of 150 lbs (68 kg), which includes |
microwave oven and items placed inside the microwave oven |
and upper cabinet. |
Parts Supplied
For reorder information, see “Replacement Parts” section.
NOTE: The hardware items listed here are for wood studs. For other types of wall structures, be sure to use appropriate fasteners.
A 
B 
CD 
E 
F
G
■ Grounded electrical outlet inside upper cabinet. See |
“Electrical Requirements” section. |
NOTES:
■If installing the microwave oven near a left sidewall, make sure there is at least 6" (15.2 cm) of clearance between the wall and the microwave oven, so that the door can open fully.
■Some cabinet and building materials are not designed to withstand the heat produced by the microwave oven for cooking. Check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damages.
Special Requirements
For Wall Venting Installation Only:
■Cutout must be free of any obstructions so that the vent fits properly, and the damper blade opens freely and fully.
For Roof Venting Installation Only:
A.
C. Toggle nuts (2)
D. 1/4" x 2" lag screws (2) E. Sheet metal screws (2)
F. Power supply cord bushing (1)
G. Damper assembly (for wall or roof venting)
Not Shown:
Upper cabinet template
Mounting plate (attached to back of microwave oven)
Aluminum grease filters
Charcoal filters (Depending on model, charcoal filters may not be included. See User Instructions.)
■If you are using a rectangular to round transition piece, 3" (7.6 cm) clearance needs to exist above the microwave oven so that the damper blade can open freely and fully. See “Rectangular to Round Transition” illustration in “Venting Design Specifications” section.
NOTE: Depending on model, aluminum grease filter and charcoal filter may be combined.
Materials needed
■Standard fittings for wall or roof venting. See “Venting Design Specifications” section.
2
