3.IMPORTANT: After cleaning, apply a thin coat of salt-free oil to the CCCL surface units, then heat 3-5 minutes. It may still smoke slightly when heated. If surface units have dark spots caused by grease and food, the oil treatment will improve

their appearance but not elimi- nate the spots. NOTE: Optional Electrol dressing can be applied to the surface units to improve their appearance.

4.The stainless steel trim rings Will gradually yellow from the heat of the surface units and pans. This is normal. The yellowing can be removed by using stainless steel cleaner or Cook Top Polishing Creme on the trim rings.

To obtain order information

for Cook Top Polishing Creme (PN 814009) or Electrol dressing (PN 814030), write to:

Whirlpool Corporation

Attention: Customer Service Dept. 1900 Whirlpool Drive

LaPorte, IN 46305

The Oven Door

Removing the oven door will help make it easier to clean the oven.

1.

Open the door to the first stop position.

2.Hold the door at both sides and lift it at the same angle it is in.

3.To replace, fit the bottom corners of the door over the ends of the hinges.

Push the door down evenly. The door will close only when it is on the hinges correctly.

Page 15
Image 15
Whirlpool RF317PXV manual Oven Door