Whirlpool RH2600XL-1 manual To Install Range Hood

TO INSTALL RANGE HOOD

For most efficient operation, top of hood should be

approximately 66 (167.6 CM) inches from floor.

1. Mark locations for electrical wiring from dimensions grven in Figure 1.

2 Cut hole to accomodate electrical wiring. Be sure to

minimize openings through outside walls or the ceiling. These will have to be sealed later.

3. Run wire through wall or cabinets according to

National Electrical Code and applrcable local codes. DO

NOT turn power on until installation is complete.

4. Remove screws holding junction box cover. See Frgure 2.

5.Lrft the hood into position and mark the location of each of the four keyhole mounting slots.

6 Remove the hood and start all four screws in the center of the narrow neck of the keyhole slot marked on the cabinet bottom.

7. Lift the hood into position srmultaneously feeding

the electrical wire through the knockout.

8.	Tighten		four	mounting		screws	to secure	hood	to	Figure	2
cabrnet		Be	sure	the	screw	heads are	in the narrow	neck	of
the	keyhole		slot.	See	Figure	3.

9 Complete electrrcal wiring In the junction box

according to the National Electrical Code and applicable local codes.

NOTE, Thus unit must be permanently grounded

10Replace junction box cover. See Figure 2.

11Seal holes around wiring passing through ceiling or

outside wall with caulking or lnsulatron to prevent energy loss.

KEYHOLE SLOT

IN CANOPY

Figure 4

SCREW --

(IN INSTALLATION

PARTS BAG)

Figure 3

Page 2