II
I-
I
’VENTLESS KITCHEN RANGE HOOD FOR 12O.V. OPERATION
KITCHEN
RANGE HOOD
MODEL
Tiiifl | 01 | RH7630XL |
4a |
|
|
READ AND SAVE THESE INSTRUCTIONS
Betore you begin, read the following lnstructlons completely and carefully. It followed, they will simplify the installation job.
IMPORTANT: OBSERVE ALL GOVERNING CODES
AND ORDINANCES
1.Remove screw holding junction box cover.
2.Remove proper electrical knockout See Figure 1.
3.Lift the hood into position. Mark location of four mounting holes.
4.Remove hood and start all four screws in center of narrow neck of keyhole slot marked on cabinet bottom. (Fig.
SAVE THESE INSTRUCTIONS FOR THE LOCAL
ELECTRICAL INSPECTOR’S USE
for an easier installation, remove the filters and the three assemblies shown in Fig. 3. This reduces the weight about 40%. The blower cover and light frame assembly are held into place with thumb screws. To remove the blower assembly, first unplug the blower supply cord from the junction box. Remove the packing screw from the blower retaining rod, then pull the blower retaining rod to one side, freeing it from between the bumps on the blower housing.
2).
5.Lift into position on four screws simultaneoulsy feeding electrical wire through knockout.
8.Complete electrical wiring in junction box according to the National Electrical Code and applicable Local codes.
NOTE: This unit must be permanently grounded.
7.Tighten screws to secure hood. Be sure screw head is in narrow neck of keyhole slot.
8.Replace junction box cover.
9.Replace blower cover, light frame assembly and filters.
10.Replace blower.
TOOLS AND MATERIALS REQUIRED
l
l
Drill, electric or ratchet drive, with
One common head screwdriver (to secure hood mounting screws to the cabinet and hood sheet metal parts).
l
l
l
Pliers (for opening knockouts).
Pencil, ruler and level for marking cabinet locations.
Saber saw or keyholesaw for cutting the wall or cabinet
openings.