Whirlpool RS660BXB important safety instructions Broiling, Custom broil

2. Loosen the locking screws inside the control	Locking
knob. Note the position of the notches.

3.To lower the temperature, hokf knob handle firmly and move the tooth a notch counter- clockwise. Each notch equals about 5°F (2.5%).

4.To raise the temperature, hold knob handle firmly and move the tooth a notch clockwise. Each notch equals about 5’F (2.5%).

5.Tighten the locking screws and replace the

control knob. Tooth

Broiling

1.Position the rack properly before turning on the oven. Position rack so that the surface of the food is at least 3 inches (7 cm) away from the broil element. See “Broiling rack position chart” on page 14.

2.Put the broiler pan and food on the rack

3.Close the door to the Broil Stop position (open about 4 inches [lo cm]). The door will stay open by itseff.

4.Set the Oven Selector and Oven Temperature Control to BROIL. The OVEN HEATING Indicator Light will come on.

NOTE: Do not preheat oven when broiling.

5.When broiling is done, turn both the Oven Selector and Oven Temperature Control to OFF. The OVEN HEATING Indicator Light will go off.

Custom broil

l tl food is cooking too fast, turn the Oven

Temperature Control counterclockwise until the OVEN HEATING Indicator Light goes off.

l If you want the food to broil slower from the start, set the Oven Temperature Control Knob between 170°F and 325°F (77°C and 163°C). These temperature settings allow the broil heating element to cycle and to slow cooking. The lower the temperature, the slower the cooking.

l Fish and chicken are some foods that may cook better if you use lower broiling temperatures.

The Oven Selector must be on BROIL for all broiling temperatures.

NOTE: Leave the oven door partly open when- ever using the oven to broil. This allows the oven to maintain proper temperatures.

13