To Remove:
1.Open drawer to its full open position.
2.Locate the black
1
1.Tab
3.Press the tab down on the right side, and lift tab up on the left side at the same time, then pull drawer out another inch.
4.Holding the drawer by its sides, not its front, carefully pull it all the way out.
■Is the burner damaged? On models with caps, look for a warped cap. If cap will not spin freely on a flat surface, painted side down, the cap is warped. Switch cap with a different surface burner to check for further warping. Contact a service technician or see “Assistance or Service” section.
■Is propane gas being used? The appliance may have been converted improperly. Contact a service technician or see “Assistance or Service” section.
■Is the burner wet? Let it dry.
■Is the cookware the proper size? Use cookware about the same size as the surface cooking area, element or surface burner. Cookware should not extend more than 1 in. (2.5 cm) outside the cooking area.
To Replace:
1.Align the drawer glides with the receiving guides.
2.Push drawer in all the way.
3.Gently open and close the drawer to ensure it is seated properly on the slides.
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
■Is the power supply cord unplugged? Plug into a grounded 3 prong outlet.
■Has a household fuse been blown or has the circuit breaker been tripped? Replace the fuse or reset the circuit.
■Is this the first time the surface burners have been used? Turn on any one of the surface burner knobs to release air from the gas lines.
■Is the control knob set correctly? Push in knob before turning to a setting.
■Are the burner ports clogged? See “Surface Burners” section.
■Are the burner ports clogged? See “Surface Burners” section.
■On models with caps, are the burner caps positioned properly? See “Surface Burners” section.
■Is the proper cookware being used? See “Cookware” section.
■Is the control knob set to the proper heat level? See “Cooktop Controls” section.
■Is the appliance level? Level the appliance. See the Installation Instructions.
■Is this the first time the oven has been used? Turn any one of the surface burner knobs on to release air from the gas lines.
■Is the electronic oven control set correctly? See “Electronic Oven Controls” section.
■Is propane gas being used? The appliance may have been converted improperly. Contact a service technician or see “Assistance or Service” section.
■It is normal for the fan to automatically run while the oven is in use to cool the electronic control.
■Does the oven temperature calibration need adjustment? See “Oven Temperature Control” section.
■Is the display showing “PF”? There has been a power failure. Clear the display. See “Display(s)” section. On some models, reset the clock, if needed. See “Clock” section.
■Is the display showing a letter followed by a number? Depending on your model, press OFF/CANCEL, OFF or CANCEL/OFF to clear the display. See “Display(s)” section. If it reappears, call for service. See “Assistance or Service” section.
18