| PROBLEM |
|
| CHECK IF | |
Shrlnklng | kerns | are overdried | |||
|
| Fabric type and quality is | |||
|
| suitable for | drying | ||
Slow | drying | There | is a large | amount of | |
|
| moisture in the load to be dried | |||
|
| Cold rinse water is used | |||
|
| Room air temperature is Mow | |||
|
| 45°F | (7°C) |
|
|
|
| Dryer is exhausted according to | |||
|
| Installation | Instructions | ||
|
| Lint screen | is clogged | ||
|
| Exhaust duct or outside exhaust | |||
|
| hood | is cbgged |
| |
|
| Proper electrical supply is used | |||
Statk | electrklty | Load | is overdried | ||
|
| Fabric | softener | is used | |
|
| Synthetics, | synthetic blends, | ||
|
| permanent press and knits are | |||
|
| in bad |
|
|
|
CAUSES/SOLUTIONS
Remove items while there is still a trace of moisture. Some items should be removed while damp, then shaped and air dried.
Some knits are stretched during manufacturing. Washing and drying returns them to the original size. This is normal. Check quality of garment before buying. Follow fabric care label dire&ions carefully.
Some items hofd more moisture than others (cottons more than polyester). They take longer to dry. Full loads take longer to dry than small bads of the same fabric.
A bad rinsed in cold water will take slightly bnger to dry than a warm one. Cold rinses, however, help save energy and reduce wrinkling more than warm rinses do.
Install dryer in a room where the air temperature is warmer than 45°F (7°C). Cob air increases drying time and may cause wrinkles not to be removed.
Install and exhaust your dryer accord- ing to the Installation Instructions provided.
Clean lint screen before or after each use.
Clean if needed.
Properly connect the dryer to a grounded electrical circuit that meets the electrical requirements stated in the Installation Instructions.
Remove items while there is still a trace of moisture.
Use a fabric softener and follow package diredbns carefuliy.
Synthetics, synthetic blends, permanent press and knits build up static ebctric- ity. Use a fabric softener and be careful not to overdry the load.
14
