TROUBLESHOOTING (cont.)
To possibly avoid a service call, first try the suggestions listed here or refer to the “Assistance or Service” page.
|
| If you experience | Possible Causes | Solution |
|
|
|
|
|
|
| Cycle time too short | Automatic cycle ending early. | The load may not be contacting the sensor strips. Level the |
|
|
|
| dryer. |
|
|
|
| Use Timed Dry for very small loads. Change the Dry Level |
|
|
|
| setting on Automatic Dry cycles. |
|
|
|
| Increasing or decreasing the Dry Level setting will change the |
|
|
|
| amount of drying time in a cycle. |
|
|
|
|
|
|
| Lint on load | Lint screen clogged. | Lint screen should be cleaned before each load. |
|
|
|
|
|
|
| Stains on load or drum | Dryer fabric softener not properly | Add dryer fabric softener sheets at the beginning of the cycle. |
|
|
| used. | Fabric softener sheets added to a partially dried load can stain |
|
|
|
| your garments. |
|
|
|
| Drum stains are caused by dyes in clothing (usually blue jeans). |
|
|
|
| These will not transfer to other clothing. |
|
|
|
|
|
|
| Loads are wrinkled | Dryer tightly packed. | Dry smaller loads that can tumble freely reduce wrinkles from |
|
|
|
| forming. |
|
|
|
|
|
|
| Odors | Recent painting, staining, or | If so, ventilate the area. When the odors or fumes are gone |
|
|
| varnishing in the area where your | from the area, rewash and dry the clothing. |
|
|
| dryer is located. |
|
|
|
|
|
|
|
|
| Dryer being used for the first time. | The new electric heating element may have an odor. The odor |
|
|
|
| will be gone after the first cycle. |
|
|
|
|
|
|
| Load is too hot | Laundry items removed from the | Allow Cool Down cycle to finish before removing laundry from |
|
|
| dryer before the end of the cycle. | dryer. All cycles are cooled slowly to reduced wrinkling and |
|
|
|
| make it easier to handle. Items removed before Cool Down may |
|
|
|
| feel very warm. |
|
|
|
|
|
|
|
| High temperature cycle used or was | Select a lower temperature, and use an automatic drying cycle. |
|
|
| TEMPERATURE control set to high. | These cycles sense the temperature or the moisture level in the |
|
|
|
| load and shut off when the load reaches the selected dryness. |
|
|
|
| This reduces overdrying. |
|
|
|
|
|
11