Whirlpool W10131955B Electrical Requirements, Cabinet Dimensions, Curved-edge glass cooktops

Curved-edge glass cooktops

B

A

C

A. 21¹⁄₈" (53.7 cm)

B. 30⁵⁄₁₆" (77.0 cm) on 30" (76.2 cm) models, 36⁵⁄₁₆" (92.3 cm) on 36" (91.4 cm) models

C. 2⁷⁄₈" (7.3 cm)

Cabinet Dimensions

IMPORTANT: If installing a range hood or microwave hood combination above the cooktop, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface.

A

D

CB

NOTES: After making the countertop cutout, some installations may require notching down the base cabinet side walls to clear the cooktop base. To avoid this modification, use a base cabinet with sidewalls wider than the cutout.

If cabinet has a drawer, a 4" (10.2 cm) depth clearance from the countertop to the top of the drawer (or other obstruction) in base cabinet is required. The drawer depth may need to be shortened to avoid interfering with the regulator.

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

M

K E

FG

H

IMPORTANT: The cooktop must be electrically grounded in accordance with local codes and ordinances, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1.

This cooktop is equipped with an electronic ignition system that

LJ

JI

A. 30" (76.2 cm) on 30" models; 36" (91.4 cm) on 36" models

B. Combustible area above countertop (shown by dashed box above)

C. 30" (76.2 cm) minimum clearance between top of cooktop platform and bottom of unprotected wood or metal cabinet (24" [61 cm] minimum clearance if bottom of wood or metal cabinet is protected by not less than ¹⁄₄" [0.6 cm] flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" [0.04 cm] stainless steel, or

0.024" [0.06 cm] aluminum or 0.020" [0.05 cm] copper) D. 13" (33 cm) recommended upper cabinet depth

E.2¹⁄₈" (5.4 cm)

F.19" (48.3 cm)

G.18" (45.7 cm) minimum clearance from upper cabinet to countertop within minimum horizontal clearances to cooktop

H.Grounded outlet - Locate within 24" (61 cm) of right rear corner of cutout

I.29" (73.7 cm) on 30" models; 35¼" (89.5 cm) on 36" models

J.8³⁄₈" (21.3 cm) minimum distance to nearest left and right side combustible surface

K.2⁷⁄₈" (7.3 cm) minimum distance to rear combustible surface

L.Gas line opening - Wall: anywhere 5" (12.7 cm) below

underside of countertop. Cabinet floor: Anywhere within 6" (15.2 cm) of rear wall is recommended

M.24" (61 cm) minimum countertop depth is required

will not operate if plugged into an outlet that is not properly polarized.

If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association

One Batterymarch Park

Quincy, MA 02269

CSA International

8501 East Pleasant Valley Road

Cleveland, Ohio 44131-5575

■A 120 volt, 60 Hz, AC only, 15-amp, fused electrical circuit is required. A time-delay fuse or circuit breaker is also recommended. It is recommended that a separate circuit serving only this cooktop be provided.

■Electronic ignition systems operate within wide voltage limits, but proper grounding and polarity are necessary. Check that the outlet provides 120-volt power and is correctly grounded.

■The wiring diagrams are provided with this cooktop. See “Wiring Diagrams” section.

4