Whirlpool WWC4589BLS manual Left Bottom Hinge Assembly, Reverse Door Swing optional

Reverse Door Swing (optional)

1.Unplug the wine cooler and lay the unit on its back.

2.Unscrew the two Leveling Legs; one from the

bottom hinge on right and one from the left side of the unit (see Fig. 3 and Fig. 4 for locations).

3.Remove the bottom hinge by unscrewing its three (3) screws ( Fig. 2).

NOTE: Keep this hinge in a safe place incase you need to return to a right hand door swing.

4.Carefully remove the door and set aside by sliding it downward off of the top hinge pin.

5.Remove the two (2) plastic screw caps located on top of the hinge cover ( Fig. 1).

6.Remove the top hinge cover by removing its two (2) screws ( Fig. 1).

7.Remove the top hinge by unscrewing its three (3) screws ( Fig. 1)

8.Remove the plastic door pin cap from the top left side of the door and transfer it to the right side of the door.

9.Remove the three (3) Plastic Screw Caps from the top left side of the cabinet and transfer them to the top right side of the cabinet ( Fig.6 ).

10.Install the top hinge on the left side of the unit and secure with three (3) screws. ( Fig. 1 )

11.Install the hinge cover back on the top hinge and secure with two (2) screws. ( Fig. 1)

12.Install the two (2) plastic screw caps on the hinge cover. ( Fig. 1)

13.Carefully install the door on the cabinet (insert upper door into top hinge pin).

14.Using the left-side bottom hinge supplied with your unit ( Fig.5 ): insert the hinge pin into the bottom of the door, then align the holes in the hinge with the holes in the cabinet and secure hinge to cabinet with three (3)screws.

15.Install the Leveling Leg formerly attached to the right bottom hinge ( Fig.4 ) onto the new left bottom hinge, and install the Leveling Leg from the former left side position into the right side position ( Fig.3 ).

16.Check door alignment, door seal and ensure the door lock slides comfortably into the lock chamber. Tighten all hinge screws.

Fig.5

Left Bottom

Hinge Assembly

IMPORTANT!

Allow the unit to stand upright for at-least 1 hour before putting the unit into operation.

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet. Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

Fig.6	Fig.1
	Top Hinge
Plastic Screw Caps
	Assembly

Fig. 2

Right Bottom

Hinge Assembly

Fig.3

Leveling Leg

Fig. 4

Leveling Leg for Bottom Hinge

5