OPERATION
may be unavoidable, especially with weak signals. However, here are some suggestions that may improve the reception.
1.First, make certain that the television antenna produces a clear signal under normal operating conditions (i.e., at home plugged into a standard 110 AC wall outlet). Also, ensure that the antenna cable is properly shielded and of good quality.
2.Change the relative positions of the inverter, antenna cables and television power cord.
3.Isolate the television, its power cord and antenna cables from the 12 volt power source by running an extension cord from the inverter to the television set.
4.Coil the television power cord and the input cables running from the 12 volt power source to the inverter.
5.Attach a "Ferrite Data Line Filter" to the television power cord. More than one filter may be required. These filters are available at most electronic supply stores including Radio Shack. (Radio Shack Part Number is
Note:
Inexpensive sound systems may emit a "buzzing" sound when operated with the inverter. This is due to inadequate filters in the sound system. There is no solution to his
OPERATION
problem short of purchasing a sound system with a higher quality power supply.
For You Microwave Chefs.
The power rating commonly associated with microwave ovens is the "cooking power" which is the power being "delivered" to the item being microwaved. The actual operating power requirement rating is higher than the cooking power rating and typically is referenced on the back of the microwave. If the operating power requirement does not appear on the back of the microwave, check the owner’s manual or contact the manufacturer.
Some Powerful Advice.
Your Whistler inverter will work best when placed on a reasonably flat surface. The floor or wall of your vehicle are good locations.
When driving with the inverter in operation, make certain that neither the inverter nor the power cords will impede safe operation of your vehicle. Keep the unit and all cords clear of the steering wheel, gas, brake and clutch pedals and gear shift.
To maintain your inverter in proper working condition, note the following important safety precautions:
•MOISTURE. Keep the inverter dry. Do not expose it
20 | 21 |
