TROUBLESHOOTING
PROBLEM: TV Interference
Problem | Solution |
Electrical interference from | Add a Ferrite data line filter |
inverter. | on to the TV power cord. |
| This filter is available at |
| Radio Shack, |
| part number |
|
|
PROBLEM: Low or No Output Voltage | |
Problem | Solution |
Using incorrect type of | Use true RMS reading |
voltmeter to test output | meter. |
voltage. | See "For You Technical |
| Types" |
| Section of this manual. |
|
|
TROUBLESHOOTING
PROBLEM: Low Battery Alarm On All The Time
Problem | Solution |
Input voltage below | Keep input voltage above |
10.5 volts. | 10.5 volts to maintain |
| regulation. |
Poor or weak battery | Replace battery. |
condition. |
|
Inadequate power being | Use lower gauge wire. |
delivered to the inverter |
|
or excessive voltage drop. |
|
|
|
Red LED On | |
Problem | Solution |
Equipment has a high | Turn inverter power switch |
start up surge. | OFF (O) and then ON (l) |
| again until the inverter |
| powers your appliance. |
| Repeat as necessary |
| to get your appliance |
| "started". |
Battery voltage below | Recharge or replace |
10 volts. | battery. |
Equipment being operated | Use a higher capacity |
draws too much power. | inverter or do not use this |
| equipment. |
Inverter is too hot (thermal | Allow inverter to cool. |
shutdown mode). | Check for adequate |
| ventilation. Reduce the |
| load on the inverter to |
| rated continuous power |
| output. |
20 | 21 |
