White Rodgers 1E65-144 specifications Operator Save these instructions for future use

1E65-144

Non-programmable Electronic Digital Thermostat

For Line Voltage Applications

INSTALLATION AND OPERATION INSTRUCTIONS

Operator: Save these instructions for future use!

DESCRIPTION

The 1E65-144 thermostat has been designed to control electric heating systems such as baseboard heaters, radiant floors, radiant ceilings and convectors.

The adapter plate is used to offset the thermostat when an obstruction
prevents the thermostat from being mounted directly to the junction	Temperature
box.	Display

The thermostat cannot be used with the following:

-a resistive load under 2 A

-a resistive load over 16.7 A

-systems driven by a contactor or a relay (inductive load)

-central heating systems

Parts Supplied:	Available Accessories:
One (1) thermostat	F61-2642 Adapter Plate
Two (2) 6-32 pan head screws

Temperature

Adjustment

Buttons

Light

Button

System

Switch

SPECIFICATIONS

Supply: 120/240 VAC, 50/60 Hz

Minimum load: 2 A (resistive only) 500 W @ 240 VAC 250 W @ 120 VAC

Maximum load: 16.7 A (resistive only) 4000 W @ 240 VAC 2000 W @ 120 VAC

Setpoint range:	7°C to 32°C (45°F to 90°F)
Display range:	0°C to 37°C (32°F to 99°F)
Display resolution:	0.1°C (1°F)
Shipping:	–20°C to 50°C (-4°F to 120°F)
Approval:

PRECAUTIONS

! WARNING

*Failure to read and follow all instructions carefully before installing or operating this control could cause personal injury and/or property damage.

*All wiring must conform to local and national electrical codes and ordinances.

*To prevent electrical shock,personal injury,and/or equipment damage, disconnect electric power to system at main fuse or circuit breaker box prior to installation or service.

INSTALLATION

Installation should be done by a qualified heating and air conditioning contractor or licensed electrician.

Loosen the screw holding the thermostat cover to the base, open cover on hinge and remove the cover.

Optional: Use the adapter plate accessory if you need to offset the mounting holes on the junction box. Align and affix the wall plate to the electrical junction box using two 6-32 flat head screws included with the plate.

Screw

White-Rodgers is a division	PART NO. 37-6862D
of Emerson Electric Co.	Replaces 37-6862C
www.white-rodgers.com
	0839