| 3L09 |
Limit Controls | |
| INSTALLATION INSTRUCTIONS |
Operator: Save these instructions for future use!
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE PERSONAL INJURY AND/OR PROPERTY DAMAGE.
This series of limit controls has a normally closed SPST switch that opens on temperature rise to limit the maxi- mum allowable temperature in forced air heating sys-
DESCRIPTION
tems. A small bimetal sensing element is located in the air stream for quick response. These controls have a fixed temperature setting and fixed differential.
THIS CONTROL MUST BE INSTALLED BY A QUALI- FIED INSTALLER.
All wiring must conform to local and national electrical codes and ordinances.
This control is a precision instrument, and should be handled carefully. Rough handling or distorting compo- nents could cause the control to malfunction.
This control has been accurately calibrated at the factory. Any attempt to
!WARNING
Do not use on circuits exceeding specified volt- ages. Higher voltages will damage control and could cause shock or fire hazard.
If in doubt about whether your wiring is millivolt, low or line voltage, have it inspected by a quali- fied heating and air conditioning contractor or a licensed electrician.
PRECAUTIONS
!CAUTION
To prevent electrical shock and/or equipment damage, disconnect electric power to system at main fuse or circuit breaker box until installation is complete.
Label all wires prior to disconnection when ser- vicing controls. Wiring errors can cause improper and dangerous operation.
Following installation or replacement, follow appliance manufacturers’ recommended instal- lation/service instructions to insure proper op- eration.
|
| SPECIFICATIONS |
|
| |
ELECTRICAL RATING: | Temperature Setting: | |
Resistive: 15 amps @ 120 VAC | Fixed setting stamped on control | |
13 amps @ 240 VAC |
|
|
9.3 amps @ 277 VAC |
|
|
Inductive: 5.8 FLA, 34.8 LRA @ 120 VAC
2.9FLA, 13.0 LRA @ 240 VAC Pilot Duty: 278 VA
INSTALLATION
This control must be mounted in the air stream of the appliance. Follow the original equipment manufacturers’ recommendations for proper location and wiring.
Wiring
All wiring must conform to local and national
electrical codes and ordinances.
EMERSON ELECTRIC CO.
9797 REAVIS ROAD
ST. LOUIS, MISSOURI
PART NO.
Printed in U.S.A.
9949