White Rodgers 80 owner manual For Your Safety Read Before Operating, What To Do If You Smell Gas

035-14411-000 REV A (899) Form 650.74-O2Y

ïIf the blower is running, wait until it shuts off automatically.

WARNING

Turn off all electrical power to the furnace.

ïMake sure all metal surfaces of the furnace have cooled to room temperature before beginning.

FOR YOUR SAFETY,

READ BEFORE

OPERATING:

WARNING

[

If you do not follow these instructions exactly, a fire or explosion may result, causing property damage, personal injury or loss of life.

a.This appliance does not have a pilot. It is equipped with an igni- tion device which automatically lights the burners. Do not try to light the burners by hand.

b.BEFORE OPERATING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU

SMELL GAS:

ïDo not try to light any appliance.

ïDo not touch any electrical switch; do not use any phone in your building.

ïExtinguish any open flame.

ïImmediately call your gas sup- plier from a neighbor's phone. Follow the gas supplier's instructions.

ïIf you cannot reach your gas supplier, call the fire depart- ment.

c.Use only your hand to operate ON/OFF switch or to turn the gas control knob. Never use tools. If the knob will not turn by hand, don't try to repair it. Call a qualified service techni- cian. Force or attempted repair may result in a fire or explo- sion.

WARNING

Do not use this furnace if any part has been under water. Immediately call a qualified service techni- cian to inspect the furnace and to replace any part of the control system and any gas control which has been underwater.

LIGHTING

INSTRUCTIONS

1.STOP! Read all preceding safety information.

2.Set the thermostat to lowest setting.

3.Turn off all electrical power to the appliance.

4.This furnace is equipped with an ignition device which auto- matically lights the burners. Do not try to light the burners by hand.

5.Remove the control access panel.

6.Turn gas control switch to OFF.

7.Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow step B in the preceding safety informa- tion. If you don't smell gas, go to the next step.

8.Turn gas control switch to ON. Do not force.

9.Replace control access panel.

10.Turn on all electrical power to the appliance.

11.Set thermostat to the desired setting.

12.The unit will go through a 17- second igniter warm-up period. Then if the unit does not light within 7 seconds, the unit will go through two additional cycles before locking out.

13.If the furnace will not operate, shutdown furnace per the fol- lowing instructions and call your service technician or gas supplier.

Unitary Products Group 3