PROPER INSTALLATION AND LOCATION
LOCATION
∙The water dispenser should be installed in an environment where the temperature ranges between 10ºC/ 50ºF and 33ºC / 90ºF. Relative humidity should not be higher than 90%
∙Avoid direct sunshine
∙The rear of the water dispenser should be at least 10 inches / 25 centimeters from the wall to allow for proper air circulation
∙Never place the water dispenser on carpet, foam or any other unstable surface
∙Do not place flammable items near the water dispenser
TIPS
∙If the dispenser is not going to be used for an extended period of time, turn the switches at the back to the OFF position, unplug the power cord and drain the remaining water
∙In case the hot or cold water is not needed for an extended period of time, turn off the appropriate power switch at the back of the dispenser to save electricity
WARNING: The dispenser should not be turned on until at least 3 minutes after it was turned off.
PRIOR TO FIRST TIME USE
IMPORTANT: Prior to using the Water Dispenser for the first time, the water tanks need to be flushed in order to prevent the water from tasting awkward.
The water dispenser tanks also need to be cleaned periodically to prevent buildup of mineral deposits that can affect water taste and flow. To clean the water tanks:
1.Make sure that the power switches are in the OFF position
2.Create a solution of one quart of water with either one quart of vinegar or four ounces of lemon juice. Make enough so you can fill the water tank all the way to the top.
3.Remove the bottle supporter and pour the solution in the opening at the top of the dispenser.
4.Let the cleaning solution sit inside the unit for about 1 hour, drain out the cleaning solution from the drain plug at the back of the unit. When no more water comes from drain plug, press the hot and cold dispenser buttons to drain out the solution.
5.Rinse the water dispenser with clean water.
6.Install the water bottle ( see Loading the Dispenser, page 5)
IMPORTANT: Before use, dispense at least one quart of water from each tap to make sure the cleaning solution is completely removed.
LOADING THE DISPENSER
IMPORTANT: Make sure the dispenser is unplugged with both the hot (red) and cold (green)power switches set to the OFF position. Before loading, wipe the top of the bottle with a clean cloth and wash hands. Avoid touching the part of the bottle that will be directly in contact with the water dispenser.
1.Invert a 3 or 5 gallon water bottle on top of the cooler and place securely on the bottle support collar
2.Press the hot and cold dispenser buttons until water runs from both taps
3.Plug in the water dispenser. Do NOT turn on both hot and cold switches at the same time.
4.Turn on the hot (red) power switch at the back, the Hot red heating LED indicator turns on and the heating system starts working. When the hot water reaches a temperature of approx. 95ºC / 203ºF, the red light turns off and the heating system stops. The machine turns to keeping warm mode. When the hot water temperature drops below 80ºC / 176ºF, the heating system will automatically resumes.
5.Turn on the cold (green) power switch, the green
5
