5. Operations
Temperature Setting
It is recommended that you install the wine cooler in a place where the ambient temperature is between (60- 80°F). If the ambient temperature is above or below recommended temperatures, the performance of the unit may be affected. For example, placing in extreme cold or hot conditions may cause interior temperature to fluctuate thus the set temperature may not be achievable.
You can set the wine cooler temperature by pressing the “
” and “
” buttons on the control panel.
Temperature settings for upper zone:
Temperature settings for lower zone:
Generally for red wines, the temperature range should be between 57ºF – 61ºF and for white wines, the temperature range should be 50ºF - 54ºF. This is based on an ambient room temperature of 77ºF.
Interior Light
You can turn on and off the interior light by pressing the “Light” button. The “Light” button on the left side controls the upper zone light and the “Light” button on the right side controls the lower zone light.
Handle Bars
Your wine cooler comes with two towel bar style handles. To install the handle, you will need a
∙Open the door of the wine cooler.
∙Located the two screw holes on the inside of the door (they may be partially obscured by the door seal so you may need to remove the door seal)
∙Insert the screws into the screw holes until they stick out of the front of the door.
∙Line up the holes in the handle with the screws and give each screw about
∙Now the turn the screws in all the way, and your handles are installed.
∙Replace seal into door frame.
Bottle Capacity
This wine cooler is designed to store 6 bottles in the upper zone and 15 bottles in the lower zone. The bottle capacity listed for your wine cooler is an estimated maximum capacity based on a standard 750ml wine bottle. For other size bottles, the capacity will vary.
