Wi-Ex YX699 manual zBoost Professional Signal Meter - Product Specifications

3.Turn on the meter with the power switch on the side of the signal meter. After a few seconds, the meter will indicate the received signal strength on the display.

4.Select the desired band by pressing the BAND button on the front of the meter. The LED will light green for the CEL band (800 MHz) or orange for the PCS (1900 MHz) band. Pressing the BAND button again will toggle the meter between the CEL and PCS bands.

5.The meter will now indicate the received signal strength of the selected band. A greater number indicates a stronger signal.

6.The directional antenna may be peaked for the strongest signal by turning the antenna and observing the display on the meter. Turn the antenna until the strongest signal (greatest number) is found.

7.Disconnect the cable and antenna, and turn off the meter when not in use to maximize battery life.

NOTE: To switch between the default numeric display (0 to 99) and the alternate dBm display (-99 to -10 dBm), press and hold the BAND button for 10 seconds, then release.

zBoost Professional Signal Meter - Product Specifications:

Frequency (downlink): 1930 – 1990MHz (1900 MHz) 869 – 894 MHz (800 MHz)

Signal Indicator Display LED: numeric display 0-99 (default) or dBm display -99dBM to -10dBm

Connectors: RF SMA (female) – PCS and CEL RF input

Battery (not included): 3 standard AA (1.5VDC) batteries (8-10 hours)

Base Unit Size: 2” x 4” x 1”

Operating Conditions: 0° to 50°C (32° to 122°F)

Storage Conditions: -30° to 125°C (-22° to 257°F)

© 2008 Wi-Ex