PRODUCT IS REPLACEMENT OF THE PRODUCT. NO PERSON HAS ANY AUTHORI- TY TO BIND WILLIAMS SOUND TO ANY REPRESENTATION OR WARRANTY WITH RESPECT TO THE PFM T31 TRANSMITTER. UNAUTHORIZED REPAIRS OR MODIFI- CATIONS WILL VOID THE WARRANTY.
The exclusions and limitations set out above are not intended to, and should not be construed so as to contravene mandatory provisions of applicable law. If any part or term of this Disclaimer of Warranty is held to be illegal, unenforceable or in conflict with applicable law by a court of competent jurisdiction, the validity of the remaining portions of this Disclaimer of Warranty shall not be affected, and all rights and obligations shall be construed and enforced as if this Limited Warranty did not contain the particular part or term held to be invalid.
PFM T31 Transmitter
Instructions For Use & Care
Thank you for purchasing the PFM T31 transmitter from Williams Sound. The T31 trans- mitter is designed to operate with a
How it Works: The T31 transmitter uses a microphone (not included) to pick up the desired sound source. The speaker talks into the microphone, and the T31 transmitter broadcasts the message over an FM radio signal. Listeners wear FM receivers to pickup the broadcast and hear the speaker’s message.
If you experience difficulty with your system, call
If it is necessary to return the system for service, your Customer Service Representative will give you a Return Authorization Number (RA) and shipping instructions.
Pack the system carefully and send it to:
Williams Sound Corp.
Attn: Repair Dept.
10321 West 70th Street
Eden Prairie, MN 55344
Components:
PFM T31 Body pack transmitter
BAT 001 AA Alkaline Batteries
Instructions:
Before you begin, make sure you have AA Alkaline batteries installed in the transmit- ter. See Battery Information on page 2.
1. | Plug the microphone into the “mic” jack |
on top of the transmitter. | |
2. | Turn the power on: Place the FM switch |
to the “On” position. | |
3. | Position the microphone as close to the |
speaker’s mouth as practical. | |
4. | When you are ready to speak, turn the |
On/Off Switch
Mic | Off | On |
| FM |
|
| Mic |
|
| Williams Sound FM |
|
Mic Jack | Mic Mute Switch | |
the switch to the “Off” position. This will eliminate any unwanted noise as a result of the transmitter being on.
Note: The microphone cord is also the transmitting antenna. For maximum range, make sure the microphone cord is hanging as straight as possible.
®
Mic Mute Switch to the “On” position. |
When you are done speaking, mute the mic |
by turning |
5.Remember to turn the transmitter off when you are done using it: Turn the “FM” switch to the “Off” position.
10321 West 70th St., Eden Prairie, MN 55344 U.S.A. 800.843.3544 952.943.2252 FAX: 952.943.2174 www.williamssound.com
MAN 109C ©2005, Williams Sound Corp.
MAN 109C ©2005, Williams Sound Corp. |
| ® |
