PhoneMax ® Model TEL 030

Installation Guide & User Manual

Bare Wall Installation

Even if you don’t have a studded wall phone plate, you can still mount the PhoneMax on any wall surface within six feet of a standard modular jack.To mount the phone farther from the jack you’ll need a longer line cord or a telephone exten- sion cord.

Step 1: Measure and mark the wall for mounting screws. Mark two points 4.0 inches apart for upper and lower mounting screws. The lower mark should be 48–52 inches from the floor. Use a level to make sure the marks are aligned vertically.

Step 2: Install the mounting screws (not included).

Use wood screws for stud mounting, anchor screws for hollow wall mounting. Drive the screws almost completely in, leaving a 18⁄ (0.125) inch space between the wall surface and the bottom of the screw head (about the thickness of two stacked pennies).

Step 3: Rotate the handset hanger to prevent the handset from falling. (see Fig. 6)

Step 4: Mount the Phonemax.

Hang the telephone on the mounting screws and push down gently until it snaps into place

Step 5: Connect the line cord to the jack on the top of the phone. Plug the other end of the line cord into a modular wall jack.

Make sure it snaps firmly into place.

Step 6: Check for the dial tone.

If you can’t hear a dial tone, see In Case Of Difficulty, page 12.

Note: To disconnect the telephone, squeeze the clip on the modular plug and pull it out of the jack.

Williams Sound ®

9

Helping People Hear

Page 9
Image 9
Williams Sound TEL 030 user manual PhoneMax Model TEL Bare Wall Installation