12
11
2. To remove tough wrinkles, pump the button at 5-second
intervals for a concentrated blast of steam (D).
3. When finished ironing, turn the fabric-select dial to lowest heat
setting, move the dry/steam selector to
J
K
L
M
O
and unplug the
iron.
IRONING WITH SPRAY
use to dampen tough wrinkles at any setting (E).
1. Be sure the iron is filled with water.
2. on first use, pump the button several times.
FOR DRY IRONING
1. Make sure dry/steam selector is set to
J
K
L
M
O
(F).
Note: It is recommended that you empty the water
(see “Emptying Water Tank After Ironing”).
2. Turn the fabric-select dial to the appropriate setting for your
fabric (G). See fabric guide on the heel rest and read garment’s
label to help you determine fabric type. The temperature-ready
light glows until it reaches the appropriate temperature. it then
cycles on and off during ironing.
Note: For optimum performance, let the iron stand for
90 seconds before beginning to iron.
3. When finished ironing, turn the fabric-select dial to lowest heat setting, move
the selector to
J
K
L
M
O
and unplug the iron. Stand the iron on its heel rest and allow
it to cool off.
Important: Always stand the iron on its heel rest when powered on but not in
use.
EMPTYING WATER TANK AFTER IRONING
Note: It is not necessary to empty the water after each use.
1. Turn the fabric-select dial to
J
K
L
M
O
. unplug the iron.
Stand the iron on its heel rest and allow it to cool off.
2. Empty the water by holding the iron over a sink with the tip
pointing down. Water will empty out of water-fill opening (H).
Care and Cleaning
This product contains no user serviceable parts. refer service to qualified service
personnel.
CLEANING OUTSIDE SURFACES
1. Make sure iron is unplugged and has cooled completely. Wipe the soleplate
and outer surfaces with a soft cloth dampened with water. never use abrasives,
heavy-duty cleansers, vinegar or scouring pads that may scratch or discolor the
iron.
2. After cleaning, steam iron over an old cloth to remove any residue from the
steam vents.
STORING YOUR IRON
1. check that the selector is set to
J
K
L
M
O
.
2. unplug the iron. Stand the iron on its heel rest and allow it to cool off.
3. Store vertically on its heel rest to prevent water leaking from the soleplate,
or you can empty the water tank.
D
E
F
G
H