Router Table Insert Installation Instructions
Note: The table may need to be cut and routed to accept this insert.
1.Decide how you want your router to be oriented in relation to the table. We suggest that the handles be aligned with the long dimension of the Table Insert. You also should consider the location of the switch, height adjustment knob & locking lever.
2.Be sure your Router Table Insert is in the proper position, with the starting pin holes to the right of the bit location.
3. Place your router upside down on top of the Router Table Insert, with the router in the desired position. You’ll be using the router baseplate as a drilling template. Before removing the baseplate, put a mark or piece of tape at the front and center of both the baseplate and the Router Table Insert. These will serve as reference points later on.
4.
5.
Next rmove the baseplate from the router and the Router Table Insert from the table top.
Turn both plates upside down, and center the router base plate on the Router Table Insert (the concentric rings will help with this alignment). Make sure the tape or marks you placed on the plates in step #3 are oriented properly.
6.
7.
8.
Clamp the Router Base Plate and the Router Table Insert together securely.
Carefully drill through the table plate, using the holes in the router base plate as guides.
Remove clamps, turn the table plate over and countersink the holes you drilled in the previous step. Run your countersink at slow speed, and use care not to countersink too deep.
9. Mount the Router Table Insert to your router. If the screws supplied with your router are too short, you can obtain longer screws from hardware or auto- motive parts stores. Lower router and plate into table and you’re ready to go!
SKU 94331 | Page 5 |
