Windsor L24H13, L27ER22, L21H13 Installing or Removing PAD Driver or Pads, Pad driver installation

MAINTENANCE

INSTALLING OR REMOVING PAD

DRIVER OR PADS

Consult an authorized distributor to assist you in selecting the correct pad for your specific needs.

Pad driver installation:

1.Tip machine on the right side (dip stick down).

2.Place pad driver on drive shaft and spin pad driver clockwise to install.

Pad Removal & Installation:

1.Tilt machine back on rear caster or service position.

2.Remove center-lock from pad driver.

3.Remove pad from pad holder.

4.Center new pad on pad driver & secure with center-lock ring.

Pad driver removal:

1.Apply down pressure on bell of machine deck.

2.Use ¾” open end wrench on top of drive shaft exposed on top of deck.

3.Strike wrench with rubber mallet to break loose the shaft from the pad driver. (counter-clockwise)

4.Remove pad driver by spinning it off counter- clockwise.

LIGHTNING 86039180 05/23/07 4-2