CAUTION: Operating the machine with | 2. After installing new belt check for clear- |
excessive pressure on the squeegee will | ance between traverse pulley and brush |
cause abnormal wear on the squeegee | drive belt. The pulley should not be in |
blades. | contact with the belt when the traverse |
BRUSH DRIVE BELT | handle is in the neutral position. |
To adjust clearance: |
BRUSH ANGLE
ADJUS-
1. Start the brush motor and lowerthe |
brush slowly to the floor. When the rear |
of the brush “A” touches the floor, the |
front of the brush “8” should be about |
\‘
1. Remove traverse drive belt by rolling belt off pulley.
2. Loosen belt tension adjusting screw and remove brush drive belt. After readjust- ing belt tension, make sure lock nut on adjusting screw Is tight.
A.Remove left side panel.
B.Loosen lock nuts on link rod. Adjust bracket on link rod so pulley does not contact belt. Retighten lock nuts on link rod.
3/16” from the floor. |
2. BY releasing the foot lift pedal the |
Springs will allow the brush to rest com- |
pletely on the floor. |
A. If the brush vibrates while in opera- |
tlon Increase dirtanu “B”. |
B. If the machine pulls to the left during |
operation decrease dlrtanu “B”. |
3. The springs (C) should be adjusted so as |
to maintain the distances as shown. |
4. To change brush inclination, IOOSen nut |
(D) and turn |
angle Is reached. |
TRAVERSE DRIVE BELT
1.With operating handle in neutral position, roll belt off pulley. Replace as required.
A