11. VACUUM MOTOR
(Refer to the Vacuum Group in the parts section of manual)
! |
Do not use a pressure washer to clean around the vacuum motors. Use tap pressure only. Care must be taken so that water is not directed into vacuum motor air intakes.
CHANGING VACUUM MOTOR
1.Disconnect batteries from machine.
2.Remove front cover.
3.Disconnect electrical connector to the vacuum motor.
4.Loosen clamp and disconnect hose from vacuum intake.
5.Remove vacuum motor mounting bracket bolts.
6.Remove vacuum motor from mounting bracket.
7.Reverse steps to install.
Vacuum Motor Carbon Brushes Replacement (Windsor)
End Cap
Carbon
Brushes
If armature commutator is grooved, extremely pitted or not concentric, the motor will need to be replaced or sent to a qualified service center.
Important:
These brushes wear quicker as the length shortens due to increased heat. Spring inside brush housing will damage motor if brushes are allowed to wear away completely.
38 [9.5mm]
Periodically check the length of the carbon brushes. Replace both carbon brushes when either is less than 3/8" (9.5mm) long.
MAINTENANCE
Vacuum Motor Carbon Brushes Replacement (Ametek)
End Cap
Carbon
Brushes
If armature commutator is grooved, extremely pitted or not concentric, the motor will need to be replaced or sent to a qualified service center.
Note: Place stop in groove.
Important:
These brushes wear quicker as the length shortens due to increased heat. Spring inside brush housing will damage motor if brushes are allowed to wear away completely.
3/8 (9.5mm)
Periodically check the length of the carbon brushes. Replace both carbon brushes when either is less than 3/8" (9.5mm) long.
CUTTER 24V (SCE) 86037010 02/21/07 |
|
|
