Winegard MV3535T DIRECTV programming, DISH Network programming DISH, To install the “SW42” switch

To toggle between satellites when subscribing to multi-satellite programming—

The MV3500T will toggle between the primary and seconday satellites for either DISH Network or DIRECTV. Both have programming on more than one satelite. When a channel is selected on the remote control and is not on the satellite cur- rently selected, the unit will automatically toggle to the correct satellite. NOTE: The MV3500T will toggle while stationary or In-Motion.

DIRECTV programming

1.DIRECTV receivers must be set for oval dish 2 sat selection to enable toggling between primary 101°W satellite and alternate 119°W satellite only. (Consult receiver manual for procedure.) After receiver is set for the correct dish selection, when you request a channel located on a differ- ent satellite, the unit will automatically toggle to that satellite.

DISH Network programming (DISH 500)

DISH Network receivers must have the “SW42” switch installed in order to toggle between the pri- mary 119° satellite and the alternate 110° satellite. (Consult your receiver manual for the procedure to reach the “check switch” menu.)

NOTE: This “SW42 Switch” is a DISH Network® receiver setting, NOT a physical part.

To install the “SW42” switch:

1.Before turning on your MV3500T system, make sure that your satellite receiver and television are turned on and your receiver is on the “point dish” menu. (Consult your owner’s manual to reach this menu.)

2.While the vehicle is stationary, turn on the

MV3500T system and wait for signal acquisition on satellite 119°.

3.After signal is acquired, the system will continously track the signal for approximately six minutes. At the end of six minutes, the unit will enter sleep mode. You now have six minutes to complete Check Switch test. Consult your re- ceiver manual for instructions on running the test. Be sure that Superdish and Alternate are un- checked if applicable. Onscreen options may vary by receiver.

4.During the Check Switch Test, the receiver will begin checking the switch by toggling between satellites. When this is completed, SW42 will ap- pear on the screen. It will be at the top of the screen, satellite designations will be below, show- ing odd and even transponders. See illustration.

If a switch other than SW42 appears, or you have an X in one of the boxes below the satel- lites, repeat Check Switch Steps.

5.Your system is now set up to toggle between satellites. It will automatically move to the correct satellite when a channel is selected with your re- mote control.

NOTE: Once these steps are completed, you won’t have to perform this test again, unless Check Switch was performed on another satel- lite dish, such as a home dish.

!satellite dish will move from the primary to the alternate satellite in order to receive multi-satellite programming.Toggle: Your Winegard automatic

Install Summary

SW42

Input:	1	1	1	1
Satellite:	119	119	110	110
Polarity:	Odd	Even	Odd	Even
Status:	Satellite reception verified
	Superdish			Alternate
	Cancel		Test	Help

Check Switch screen display

NOTE: Be sure the “Superdish” and “Alternate” boxes ARE NOT checked.

5

Rev. 6/06