Reflector
0 Degrees Elevation (Next Mark Indicates 50)
FIGURE 1
| 40 |
Reflector Support | 45 |
| |
Post |
|
| 50 |
55
60
65
75
LNBF
Clamp Knobs
Use Front of Slide Bracket for Proper Degree of Elevation Required. Unit shown at 50o.
Point Towards Satellite
RETURNINGANTENNATOTRAVELPOSITION
STEP 1. Turn receiver and TV OFF.
STEP 2. Disconnect coax from receiver.
STEP 3. Loosen clamp knobs and put antenna in travel position. See Figure 3.
STEP 4. Coil coax under base. See Figure 4.
NOTE: The carton the system came in is designed to be reused. It is suggested that you store your system in it when not in use.
Use Front of Slide Bracket for Proper Degree of Elevation Required. Unit shown at 60o.
FIGURE 2
TOP VIEW
NOTE: When ready to use antenna again, you must uncoil the coax before raising antenna. The antenna will not raise if the coax is coiled up under the base.
Coil Coax
Around
Clips
FIGURE 3 | FIGURE 4 |
