Winegard HD-7010, HD-7015 Installed in Factory, YA- Models only Attaching Coax for Yagi Models

FOR MODELS WITH REFLECTOR BOOMS Fig. 1

INSTALLED IN FACTORY

Remove antenna from carton and unfold elements on reflector booms until they lock into place. See Figure 1.

YA- MODELS ONLY

ATTACHING COAX FOR YAGI MODELS

Attach cartridge housing bottom to cartridge housing top already attached to antenna by aligning tabs and snapping into place. See Figure 5.

Fig. 5

CARTRIDGE HOUSING TOP

Unfold reflector booms until they lock into place. See Figure 1.

Fig. 2

FOR ALL MODELS

Unfold all other elements until they lock into place. Be sure the elements are locked into position and are flat and parallel to each other. See Figure 2.

Slide weatherproof boot onto coaxial cable and install connector. Attach cable to down- lead connection. Slide boot over connector and boot collar.

ATTACHING COAX FOR HD- MODELS STEP 4. Be sure to unfold tetrapole elements away from boom. Loosen wing nuts on down- lead connections. Attach matching trans- former ends to the studs between the washers and tighten wing nuts. See Figure 6.

	CARTRIDGE
BOOT	HOUSING BOTTOM
COLLAR	DOWNLEAD JACK
	75 OHM COAXIAL
	CABLE (DOWNLEAD)
	WEATHER BOOT

Fig. 6

TETRAPOLE

ATTACH DOWNLEAD/

MATCHING TRANSFORMER HERE

	Fig. 3
FOR TWO-PIECE BOOM MODELS	BOLT
Remove nut and bolt from boom and slide
narrow end of boom into end of larger sec-
tion aligning bolt holes. Make sure elements
of both booms are on top. See Figure 3.
Reinstall bolt and nut, being sure to tighten
securely.
	NUT

Fig. 4

FOR ALL MODELS

Insert the plastic end caps. As shown in Figure 4 Use a rubber mallet to gently tap them into the antenna booms to secure them.

ATTACHING COAX FOR MODEL HD7210P ONLY

STEP 4. Attach the 75 ohm coaxial downlead to the housing. Slide weather boot over the boot collar. See Figure 7.

ATTACHING ANTENNA TO MAST

Loosen U-bolt nuts. Slide U-bolt over mast. Point small end of antenna toward stations and tighten securely. See Figure 8.

Install a second U-bolt for antennas with multiple booms. The 75 ohm coaxial cable downlead may be secured to mast by taping or by using plastic wire ties.

Fig. 7

Fig. 8	MAST CLAMP
	HEX NUT

MAST CLAMP INSERT

U-BOLT

MASTING

2” OD MAX.