5
INSTALLATIONREQUIREMENTS
IMPORTANT NOTE:
Save these Installation
Instructions for the local inspector’s use.
Please read the entire Installation
Instructions prior to installation.
This installation must be completed by a
qualified technician.
Installer:
please retain these instructions
for local inspector’s reference, then leave
them with the homeowner.
Homeowner:
please read and keep
these instructions for future reference and
be sure to read the entire Use & Care
Information prior to use.
IMPORTANT NOTE:
This appliance must be
installed in accordance with local codes. The
correct voltage, frequency and amperage
must be supplied to the appliance from a
dedicated, grounded circuit which is protected
by a properly sized circuit breaker or time
delay fuse. The proper voltage, frequency,
and amperage ratings arelisted on the
product rating plate.
Record the model and serial numbers before
installing the steamer module. Both numbers
are listed on the product rating plate located
on the underside of the module. Refer to the
illustration below.
BEFORE YOU START
IMPORTANT NOTE:
Installation and service
must be performed by a qualified installer or
service agency.
Installation of the steamer module must
meet the minimum clearance requirements
for safe operation. Refer to Site Preparation
onpage 6.
Electrical installation must be adequate
and in compliance with all local codes and
ordinances. Electrical ground is required,
refer to Electrical Requirements on page 10.
The steamer module must be installed with
adrain connection and access to the drain
through the base cabinet. Refer to Drain
Connection on page 8.
If the steamer module is to be used with
any combination of additional cooktop units
or modules, refer to Multiple Cooktop
Installation on page 8.
IMPORTANT NOTE:
Aventilation hood is
recommended (but not required) for use with
the Wolf electric steamer module.
This module is intended for indoor use.
WOLF STEAMER MODULE
Model ICBIS15/S
Rating plate location
Model Number
ICBIS15/S
Serial Number
Location of rating
plate under module