Wolf Appliance Company CT30S dimensions New 30 762 Induction Cooktop, Planning Information

Planning Information

New 30" (762) Induction Cooktop

M O D E L C T 3 0 I / S

I N S T A L L A T I O N N O T E S

Refer to the illustrations and specifications for overall dimensions, cut-out dimensions and installation specifics.

Wolf recommends using 33" (838) cabinets with the 30" (762) induction cooktop.

Clearance is required for the terminal block located on the bottom of the cooktop in the right rear corner.

IMPORTANT NOTE: A minimum height clear- ance of 6" (152) is required between the coun- tertop and any combustible surface directly below the cooktop. This includes upper edges of drawers located directly below unit. If a shelf is installed below the unit, a 1" (25) gap at the rear of the cabinet shelf is necessary to allow for proper ventilation. Failure to do so could result in decreased performance or product damage.

A Wolf downdraft system, Cooktop or Pro ventilation hood is recommended. When installing a ventilation hood, refer to the specific requirements of the hood for the minimum dimension to countertop. Also refer to the ventilation recommendation charts in the cooktop or Pro ventilation sections of our website, wolfappliance.com.

The Wolf 30" (762) induction cooktop requires a separate, grounded 3-wire 240/208 V AC, 50/60 Hz, 40 amp service with its own circuit breaker. It has a 4' (1.2 m) flexible 3-wire conduit for connection at the electrical supply. Locate electrical within the shaded area shown in the Installation illustration on page 4.

A Wolf built-in single oven may be installed below this cooktop. For this installation, the electrical supply for the cooktop should be installed in the adjacent cabinet. Refer to page 6 for specifications. Be aware of the depth of the cooktop when planning for this installation.

IMPORTANT NOTE: When a built-in oven is installed below the cooktop, unless you are using cabinets deeper than 24" (610), it is recommended that the electrical supply be placed in an adjacent cabinet within reach of the conduit.

IMPORTANT NOTE: Wolf induction cooktops are designed and agency approved for installa- tion with Wolf built-in ovens only.

You must follow all National Electrical Code regulations. In addition, be aware of local codes and ordinances when installing your service.

If the 30" (762) induction cooktop is to be used with any combination of additional cooktop units or modules with a filler strip, the cut-out width increases to 29" (737). When multiple cooktops or modules are installed side by side, refer to the countertop cut-out dimen- sions on page 7.

Refer to the installation instructions shipped with each Wolf product for detailed specifications.

This cooktop is intended for indoor use only.

Dimensions in parentheses are in

millimeters unless otherwise specified. 5