Woods Equipment RD990X manual Assembly, Install Quick Hitch Optional

1.A-Frame Arm

2.Sleeve, .94 x 1.44 x 2.75 (Cat 2 Only)

3.Sleeve, .94 x 1.44 x 1.94 (Cat 1 Only)

4.Sleeve, .81 x 1.25 x 2.12

5.Sleeve, .88 x 1-1/8 x 19/32

6.3/4 Flat Washer

7.3/4 NC x 5-1/2 HHCS GR5

8.3/4 NC Hex Nut

9.1/2 Flat Washer

10.1/2 NC x 6 HHCS

11.1/2 NC x 2 HHCS

12.3/8 Chain, 38-Link

Figure 33. Quick Hitch Kit Installation (Optional)

Install Quick Hitch (Optional)

NOTE: This kit allows mower to fit Category 1 or Category 2 standard quick hitches.

1.Lower hitch arms must be located in center attachment hole. See Figure 33 for adjustment.

2.For use with Category 1 quick hitch, lower hitch arms should be positioned with offset toward inside of mower. For use with Category 2 quick hitch, lower hitch arms should be positioned with offset toward outside of the mower.

3.Remove clevis pins from lower hitch arms. Pins will not be used for quick hitch.

4.Attach A-Frame arms (1) and sleeve (2) to lower hitch arms using cap screws (7), sleeve (5), washers (6) and hex nut (8).

5.Attach upper end of A-Frame arms (1) and sleeve

(4)to U-bracket, using cap screw (7), washers (6) and hex nut (8).

6.Remove rear offset links. They will be replaced with chains (12).

7.Attach chains (12) to top of A-frame on both sides as shown, using cap screw (10), washers (9), and flange lock nut.

8.Attach opposite ends of chains (12) to rear mower frame using cap screws (11), washers (9), and flange lock nut. Vary length slightly as desired. Twist chain to make finite adjustments in length until unit lifts level.

9.Tighten all hardware.

32 Assembly MAN0845 (1/12/2011)