W1716 Installation
The SHOP FOX® W1716
W1716 Hardware Bag Contents: | Qty | |
• Cap Screws | 4 | |
• | Flat Washers 5⁄16" | 8 |
• | Flat Washers 1⁄4" | 6 |
• | Hex Nuts | 8 |
• Hex Bolts | 6 | |
• Flat Head Screws | 4 | |
• | Hex Key 6mm | 1 |
• | Hex Key 4mm | 1 |
To install the fence rail to the table saw, do these steps:
1.Install the rear rail bracket (long angle iron) to the back side of the table (Figure
2), with the four 5⁄16" cap screws. The holes in the extension wings are not threaded and require 5⁄16" nuts and washers to secure them.
2.Install the front fence rail bracket.
—If your table saw has cast iron extension tables, install the front rail bracket to the main table with two
—If your table saw has sheet metal exten- sion tables, install the front bracket to the main table with two
If the extension tables do not have mounting holes, or if the holes in the front fence rail bracket and extension tables do not align, drill 5/16" holes into the extension tables.
3. Align the front rail (rectangular tubing) threaded holes over the front rail bracket holes and secure it in place with the pro- vided six
5 | |
| |
|
|
Figure 2. Rear fence rail bracket.
Main Table Mounting
Locations
Sheet Metal Extension
Wing Mounting Locations
Figure 3. Front fence rail bracket.
Figure 4. Installing fence tubing.
ASSEMBLY