Model W1746
Fine Air Filter
Instruction Sheet
Introduction
Your new SHOP FOX® Model W1746 Fine Air Filter is spe- cially designed to filter out particles that are 0.3 microns or larger in size. Some of the typical particles that the filter will remove are smoke, dust mites, pollen, mold spores, and general airborne debris. However, the result- ing air quality will depend on the size of the room and the ventilation. This fan is not designed to operate in wet environments or environments with flammable gasses. Place the fan on the floor, desk, table, or file cabinet; begin fan operation, and enjoy cleaner air in the office or at home immediately.
Operation
Push the FAN ON/OFF button to select: Power ON, 200
CFM on High, 140 CFM on Medium, and 100 CFM on Low.
Push the FAN OFF DELAY button to select continuous operation,
Maintenance/Service
The filter cannot be cleaned, and must be replaced with a new 13.25" x 14.25" x 1.25" 0.3 micron filter.
Note: For a modified room fragrance, you can install an aftermarket fragrance sponge in the drawer at the back of the fan unit.
To replace the filter element, do these steps:
1.DISCONNECT THE FILTER UNIT FROM POWER!
2.Do the three steps shown in Figure 1, on each side of the fan unit. DO NOT PRY ON OR FORCE THE COVER OFF!
3.Wipe out the filter housing and replace the filter ele- ment.
4.Reinstall the front cover and snap it back into place.
(2)
Push
grille
edge in here to unlatch hook.
(1)
Push
side
button
in.
(3)
Slide cover upwards while holding button in and pushing on grille edge.
Figure 1. Filter access.
