Model W1796/W1797
CLEANING & LUBRICATION
Cleaning
Proper cleaning is the best way to ensure trouble free performance from your spray gun. If your gun is not thoroughly cleaned, damage and poor spraying will result. Problems caused by improper cleaning will not be covered by the warranty. Clean the spray gun immediately after each use.
To clean your spray gun:
1.Spray a small amount of solvent through the spray gun.
Note: Check with local laws regarding this practice. If you are spraying on a regular basis, spraying solvents into the air may be illegal. A cabinet style spray gun cleaner may be required.
2.DISCONNECT SPRAY GUN FROM AIR!
3.Unscrew the cup.
4.Disassemble the gun by unscrewing the fluid control knob, removing the spring and needle (Figure 10).
Fluid Tip | Filter | Cup |
| ||
|
| Fluid |
| Needle | Control |
|
| Knob |
Atomizing |
|
|
Cap | Spring |
|
|
|
Figure 10. Disassembly for cleaning.
5.Unscrew the atomizing cap with your fingers and the fluid tip with the service wrench. The fully disassembled gun should look like
Figure 10.
6.Rinse these parts thoroughly in solvent then dry with compressed air or let air dry.
Note: If the small holes in the atomizing cap become blocked, soak in clean solvent. If the blockage still exists, clear the blockage with a small needle, taking great care not to enlarge or damage the hole. Damage to the hole will create a disrupted spray pattern.
7.Use the cleaning brush with solvent to clean the inner orifice and other hard to reach areas on the outside of the spray gun body.
8.Wipe the rest of the gun body with a shop towel and dry.
EXPLOSION HAZARD! Chlorinated Solvents like Tricloroethane and Methylene Chloride (methyl chloride) can chemically react with aluminum and may explode. Many parts in spray guns are made of aluminum. Read solvent label carefully before using solvent.
NOTICE
DO NOT soak the spray gun body in solvent. Prolonged exposure to solvent will rapidly deteriorate the spray gun washers and seals. Ignoring this notice will void your warranty.
