Woodstock W2005 instruction manual Blade Guard, Magnetic Switch

Blade Guard

The SHOP FOX ® Classic Fence is intended to work with all table saw blade guards. After installing the rear rail you will be able to reinstall the guard assembly without interference with the rail. A typical installation is shown below in Figure 8.

If you have any questions or concerns about the blade guard on your saw working in conjunction with the new fence, please see your dealer or contact Woodstock’s Technical Support.

DO NOT operate the saw without a blade guard installed. Operating without a guard creates a risk of injury from kickback or flying debris. If you encounter any difficulty with reinstalling the blade guard with the new fence system, contact Woodstock’s Technical Support.

Figure 8. Rail and guard bracket installation.

Magnetic Switch

At the left hand edge of the front rail there are pre-drilled holes which can be used to mount the table saw ON/OFF switch to the rail. This relocation of the magnetic switch makes it easy to turn the saw on and off without reaching underneath the table. Consult the instruction manual for your saw table to determine whether it is possible to locate your switch on the rail. Mount the switch to the rail using the 1⁄4-20 X 3⁄4" flat head screws, 1⁄4-20 hex nuts, and 1⁄4" flat washers.

Always make certain the saw is disconnected from the power supply before opening the switch box.

-10- Shop Fox® Classic Fence