15
Service
Lamp Replacement
DANGER: Disconnect fixture from line voltage before replacing
lamp.
WARNING: Lamp and lamp mounting surfaces are hot! Allow lamp to
cool before replacing.
Disconnect fixture from AC power.
Remove lamp plate by removing mounting screws as shown in figure
1.1 and pull lamp assembly straight back from reflector.
Grasping lamp by the base remove old lamp from the socket.
CAUTION: Touching the glass lamp envelope can reduce lamp life.
Handle new lamps with a clean cloth. Fingerprints can be
cleaned off lamp envelope with alcohol and a clean cloth.
Insert new lamp into base. Lamp is fully seated when spring clips snap
over lamp base.
Cleaning the Reflector
WARNING: To avoid burns or damage to the fixture, allow fixture to
cool before cleaning.
Remove Transition lid.
Remove lamp plate by removing mounting screws as shown in figure
1.2 and pull lamp assembly straight back from reflector.
Remove top two reflector mount screws and washers.
Lift reflector up and back to remove from fixture.
Use clean pressurized air or a soft cloth with alcohol to clean the
reflective surface.
Reseat the reflector and secure in place by replacing the top screws
and washers.
Replace lamp plate and lid.
CAUTION: Harsh chemicals and rough cloth can damage the cold
mirror coating on the reflector. Replace damaged
reflectors.