Xantech 16-Mar, 16-Feb user manual Preset Scan Sec

5	Auto Memory	1	Start scan from the current frequency and
			write each station into preset sequentially
		2	Start scan from FM 87.5MHZ to 107.95 then
			AM 530 to 1690, write each station into preset
			sequentially.
6	RS232 Output	1	Outputs feedback one by one (i.e. on demand)
		2	Outputs feedback every 0.5 seconds
		3	Outputs feedback every 1 seconds
		4	Outputs feedback every 2 seconds
		5	Outputs feedback every 5 seconds
7		1	Scan up preset number to play each preset for 5
	Preset Scan		sec
		2	Scan Down preset number to play each preset
			for 5 sec
		3	Stop the preset scan
		4	Move and stop only once at the next preset of
			higher number
		5	Move and stop only once at the next preset of
			lower number
8	Write/Erase a	1	Enter a "0" to erase the current preset shown in
	preset		the display
		2	write the frequency into the entered number	01..32
9	Up/Down Tuning	1	Auto tune up frequency
		2	Auto tune Down frequency
		3	Manual tune up frequency one step
		4	Manual tune down frequency one step
10	Stereo/Mono	1	Let Tuner received signal control the mode
	mode
			Force the tuner into Mono mode reception
		2
			(Stero mode is
			set each time the auto-tuning is engaged)
11*	Get frequency	1	Output in ASCII, the band and frequency
			listening
	Get Preset	2	Output in ASCII, the preset number that is
	number		displaying
	Get Tuning mode	3	Output in ASCII, the current tuning in "auto" or
			"manual"
	Get Receving	4	Output in ASCII, the current receiving mode in
	mode		"Stereo" or "Mono"
	Get Operating	5	Output in ASCII, the Frequency Preset number,
	Status		Tuning Mode, Receiving Mode, Zone ID, IR ID,
			and Power status
12	Purge EEPROM	111	Purge the EEPROM and restore it to the default
			setting
13	MPU Reset	111	Reset the MPU to default settings
14	Reserved for
	future use

11/16 XT1