Xantech 283M installation instructions Black IR Opaque Mouse Shield, Connecting the Emitters

BLACK (IR OPAQUE) MOUSE SHIELD

•An optional shield, available from Xantech as model MS-1, fits over the 283M and the sensor window (Fig. 3) of the controlled component. It prevents unwanted external IR signals from passing through or leaking past it.

•Use the MS-1 when you want the equipment to respond only to the 283M, such as in zone controlled systems.

•Install it according to the instructions that come with the MS-1.

MS-1

Mouse Emitter Shield Adhesive Layer

Controlled Component

Fig. 3

Top View Side View

283M	MS-1and 283M installed
	over IR sensor window.
Emitter

CONNECTING THE EMITTERS

•Simply insert the mono mini plug of the 283M emitter into the "EMITTERS" or "OUT" jacks on any of the Xantech Connecting Blocks or Controllers.

•CAUTION: DO NOT plug emitters into the IN/OUT or HIGH OUT jacks on the 790-00 and 791-44 Connecting Blocks. To do so will destroy the emitters!

•Fig. 4 illustrates a typical basic system using 283M emitters.

•The 283M visible mouse emitter will also indicate the presence of stray IR or RF interference by randomly blinking when no IR control signal is being sent. Reposition the IR receiver or the interfering source to eliminate or reduce the random blinking. The more the random blinking is reduced, the better the system will function.

781RG		Satellite Receiver
Power Supply	IR Sensor
To 120 V AC	Window
(unswitched)
789-44		283M Emitter
Connecting Block		VCR

12VDC		CONNECTINGBLOCK	789-44	EMITTERS
IR RCVR	®
+12 VDC
GND
STATUS
IR IN

283M Emitter

AV Receiver

283M Blink-IR™

Mouse Emitter

EQUIPMENT CABINET, CLOSET, ETC.

291-00

IR Receiver

Fig. 4

Hand Held

Remote

5-18-00

2



283M