Xantech 29195D installation instructions Model, Description, Installation

MODEL

29195D

Hidden Link™ Shelf Top

Plasma Proof IR Receiver

INSTALLATION INSTRUCTIONS

DESCRIPTION

The Hidden Link IR Receiver is a small shelf-top infrared repeater assembly. It includes an IR receiver and a CB12 Connecting Block. The Hidden Link IR Receiver is equipped with a 7-foot cable and a 3.5mm stereo mini plug, which is plugged directly into the “IR RCVR” jack on the CB12. It can also be plugged into the “AUX” or “IR RCVR” jack of other Xantech connecting blocks, such as the models 789-44, CB60, and 791-44. The Hidden Link IR Receiver is primarily intended for use in installations where the connecting block is within reach of its 7-foot cable – as when installing the Hidden Link IR Receiver in a cabinet where the controlled equipment is behind closed doors.

FEATURES

•Very small package, only 2.00”L x 3.15”W x 0.70”H.

•System testing red-talk-back LED.

•Includes CB12 Connecting Block for easy system installation.

SPECIFICATIONS

•Infrared carrier frequency bandwidth: 30 - 100kHz.

•Reception range: Up to 30 feet, depending on conditions.

•Nominal reception angle: 55 degrees off axis.

•Cable requirements: See “INSTALLATION” below.

•Max. transmission length: 1 mile using 18 gauge wire.

•Maximum current output: 100mA

•Drives IR emitters through Xantech Connecting Blocks, Controllers, etc.

•Dimensions: 2.00”x3.15”x0.70” (51mm x 80mm x 18mm)

•Power requirements: +12VDC, 20mA.

INSTALLATION

QUICK-START

A typical system will use an IR receiver, several emitters, and a power supply all connected to a connecting block.

1. Connect the IR receiver to the “IR RCVR” port on the connecting block. The ‘red’ connector is installed to the ‘red’ plug.

Note: In some extended distances, additional 3-conductor may be required and can be connected to the terminals on the connecting block.

2.Connect the Emitters to the connecting block. The ‘yellow’ connector is installed to the ‘yellow’ plug.

3.Connect the power supply to the connecting block.

4.Installation complete

LOCAL SYSTEM APPLICATION

In this system a 286D Dual Blink-IR Designer Emitter is shown connected to the “OUT” jack. A single emitter could also be used, such as the model 282D or 283D. If expansion beyond two emitters is required, use a Xantech 789- 44, CB60, or 791-44 Connecting Block in place of the CB12. Do not use the CB12 in this case.