![](/images/new-backgrounds/1247628/2476287x1.webp)
INSTALLATION
QUICK-START
A typical system will use an IR receiver, several emitters, and a power supply all connected to a connecting block.
1. Connect the IR receiver to the “IR RCVR” port on the connecting block. The ‘red’ connector is installed to the ‘red’ plug.
Note: In some extended distances, additional
2.Connect the Emitters to the connecting block. The ‘yellow’ connector is installed to the ‘yellow’ plug.
3.Connect the power supply to the connecting block.
4.Installation complete
REMOTE ROOM APPLICATION
One application is to locate the IR receiver in a remote room. This will give the
The IR receiver will need the 3.5mm stereo type mini plug removed to extend the wire run to the connecting block. A
The
Input connections must be made as illustrated. To extend the emitter wires to a more distant location, you may splice in