Xantech 598-00 installation instructions Installation Instructions, Model

INSTALLATION INSTRUCTIONS

598-00

EIGHT BUTTON DRY CONTACT KEYPAD

•The 598 is an eight button, momentary, dry contact keypad. It is normally used in conjunction with the Xantech 590 Programmable Controller as shown in the illustration below.

•Requires 9-conductor cable, as shown. Use 24 gauge, stranded or solid wire, up to lengths of 5000'.

•Two 598's may be used to provide momentary switch closures for all 16 of the 590 input terminals.

•Two or more 598's may also be wired in parallel to the same terminals on the 590 where control from more than one room or area is required.

•The 598 fits into a standard single-gang J-box. 598's may also be used side-by-side in two (or more) gang J-boxes.

•A legend cutout sheet (included) contains typical component function command icons for button identification.

C

1

2

3

4

5

6

7

8

Model 598

Key Pad

(rear view)

+12V DC

Wire size typically AWG 20-24

																		Model 590
																		(rear panel)
																RES DEL SEQ PGM ON
+																	12VDC	1 2 3 4
1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16	O G		BANK
																	– +

12VDC

–

Controllers

White Striped

Ground or "–"Side (output) return wires.

Emitter, Connecting Block, etc.

5-14-99



786-00

Power

Supply

To 120 V AC Unswitched

1