Xantech DL25 installation instructions Description, Features, Specifications, Mounting

INSTALLATION INSTRUCTIONS

DL25

Dinky Link™ Surface Mount

Standard IR Receiver

DESCRIPTION

These small IR receivers have been designed for mounting in very small spaces. They may be mounted under shelf edges, cabinet ledges, in wall speakers, etc. – anywhere an inconspicuous appearance is desired. The high sensitivity of these receivers allows placement behind speaker grilles and still receive IR commands up to 60 feet away*.

FEATURES

•Wire channel for clean installation.

•System testing red-talk-back LED.

•Includes 3-Terminal Block for easy extension to remote room locations.

SPECIFICATIONS

•Infrared carrier frequency bandwidth: 30 - 60 kHz.

•Reception range: Up to 60 feet.*

•Reception angle: +/- 60 degrees.

•Cable requirements: See “INSTALLATION” below.

•Max. Transmission length: 1 mile using 18 gauge wire.

•Maximum current output: 100mA.

•Drives IR emitters through Xantech Connecting Blocks, Controllers, etc.

•Dimensions: 2.55” x 0.55” x 0.35” (65mm x 14mm x 9mm).

•Power requirements: +12VDC, 10mA.

* Depending on remote control output strength and ambient conditions.

MOUNTING

The IR receiver can be mounted to any flat surface, using the two-sided adhesive tape supplied. Two screws are included for mounting the 3-terminal block provided with the IR receiver.

An additional feature is a wire channel on the rear of the surface mount IR receiver. This will give the installer the ability to provide clean wire dressing in any direction.

1