Xantech HDMI4X1, HDMI4X4, WIC1200 installation instructions 28EXT External Emitter Adapter

28EXT External Emitter Adapter

INSTALLATION INSTRUCTIONS

DESCRIPTION

The 28EXT External Emitter Adapter is placed between a Xantech IR system and a list of approved electronic equipment that feature a rear panel IR input jack. These input jacks accept electrical IR commands without the carrier frequency, and are therefore not compatible with full range IR Receivers that output a carrier frequency along with the IR commands, such as all Xantech IR Receivers. The 28EXT interfaces and adapts a Xantech IR receiver to these rear panel IR inputs.

INSTALLATION

•Before making any connections:

•Confirm that the source equipment to be controlled is one of the devices in table A below.

•Table A below may indicate the need for a Wire-Swap Connector for some source units. If your device to be controlled requires this connector, make sure that it is securely plugged into the 28EXT output connector (the one with the black connector and the warning tag). Otherwise damage to your source unit or the 28EXT may occur, and such damage will not be covered under warranty.

•The 28EXT may not be compatible with non-Xantech IR Receivers and Connecting Blocks.

TABLE A:

APPLICATION #1 – XANTECH®

Models:

HDMI3x1, HDMI4x1, HDMI4x4, WIC1200

Connector marking: EXT IR or IR In

APPLICATION #2 – GEFEN®

Model:

Any product that uses RMT-IR Extender (for example: 3x1, 4x1, 4x4 HDMI switchers) Connector marking: EXT IR

TIP	SIGNAL
RING	+5VDC Power
SLEEVE	GROUND
Wire-Swap Connector Not Required
TIP	SIGNAL
RING	+5VDC Power
SLEEVE	GROUND

Wire-Swap Connector Not Required

APPLICATION #3 – OMNIMOUNT® PANEL MOUNTS
Model:	Motion52 Motorized Mount	TIP	SIGNAL
Connector marking: R/C		RING	+5VDC Power
		SLEEVE	GROUND
APPLICATION #4 – SIRIUS® SATELLITE TUNERS		Wire-Swap Connector Not Required
Model:		TIP	+5VDC Power
SCH2P Sirius Connect Home Pro Tuner		RING	SIGNAL
Polk Audio®/Sirius SR-H1000 Home Tuner		SLEEVE	GROUND

Wire-Swap Connector Required

Connector marking: IR INPUT